In Stock 1Set Mk3 Drive Gear For Upgrade Prusa I3 Mk2/Mk2S/Mk2.5 3D Printer
1 Đánh Giá
3 Đã Bán
28
62.000 đ
Xem sản phẩm trên ShopeeQuốc tế
chủ nhật 11/07/2021 lúc 06:07 SA
How to use, pls follow the steps:
1. Press the nuts to the slots on both sides of the idler
2. Insert both bearings in the pulley,Be aware that bearings can slip out during assembly.(Layers might be visible in this printed part due to the geometry .The functionality and strength remain unaffected)
3. Ensure both bearings are inside the pulley!
4. Insert the pulley in idler as shown in the picture.
5. Slide the shaft through the idler and pulley.Use reasonable force or you will BREAK the printed part.
6. Place your finger on the bearing and ensure it can rotate freely.
colour:Silver
Material:metal
Package Contents:
1 * pulley (with the lock screw)
1 * pulley (without the lock screw)
2 * pulley bearing
2 * Nuts
1 * pulley shaftOnly the above package content, other products are not included.
Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.
1. Press the nuts to the slots on both sides of the idler
2. Insert both bearings in the pulley,Be aware that bearings can slip out during assembly.(Layers might be visible in this printed part due to the geometry .The functionality and strength remain unaffected)
3. Ensure both bearings are inside the pulley!
4. Insert the pulley in idler as shown in the picture.
5. Slide the shaft through the idler and pulley.Use reasonable force or you will BREAK the printed part.
6. Place your finger on the bearing and ensure it can rotate freely.
colour:Silver
Material:metal
Package Contents:
1 * pulley (with the lock screw)
1 * pulley (without the lock screw)
2 * pulley bearing
2 * Nuts
1 * pulley shaftOnly the above package content, other products are not included.
Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.